subject
Engineering, 17.06.2020 22:57 Abarrett7323

Terminal velocity of a falling ball: For objects falling through air, the drag law is not linear but quadratic. A ball of mass m is released from rest and falls through the air under gravity. Air resistance exerts a drag force with magnitude kv2 in a direction opposite to the velocity of the ball, with k being a constant. (a) Write down a force balance on the ball. What is the terminal velocity of the ball? (no need to solve differential equations to answer this) (b) Set up the differential equation for the velocity of the ball as a function of time v(t). Write down the the initial conditions. (c) Solve the differential equation in (b) for v(t). Check that your solution satisfies the initial conditions and approaches the terminal velocity you expect from (a) as t + 0. (Hint: You will need to use a partial fraction decomposition to solve.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 05.07.2019 04:30
Technician a says that in a worm gear steering system, most excessive steering free play is usually found in the gearbox. technician b says that in a rack-and-pinion steering system, excessive free play can be found in the bushings. who is correct?
Answers: 2
question
Engineering, 06.07.2019 02:30
Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.
Answers: 3
You know the right answer?
Terminal velocity of a falling ball: For objects falling through air, the drag law is not linear but...
Questions
question
Business, 24.09.2019 23:00
question
English, 24.09.2019 23:00
Questions on the website: 13722360