Engineering, 13.06.2020 15:57 paytonpaige22
Using Circuit 5.1, answer the following questions. Calculate the voltage across the capacitor, assuming that the circuit has been left for a significant amount of time after the power supplies are connected to the other components (this is the initial voltage, vc(0- )). 2. At t = 0, the 10V source is turned off (V=0). Determine how the voltage across the capacitor changes as a function of time. That is, determine an equation for vc (t). a. Find vc(0+) b. Find vc([infinity]) c. Find d. Write an equation for vc (t) e. Calculate the voltage for the following times: t = , t = 2, t = 3, t = 4, t = 5, t = 6, t = 10,
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 19:20
Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.
Answers: 1
You know the right answer?
Using Circuit 5.1, answer the following questions. Calculate the voltage across the capacitor, assum...
Questions
Mathematics, 25.03.2020 06:37
Social Studies, 25.03.2020 06:37
Mathematics, 25.03.2020 06:37
English, 25.03.2020 06:37
Computers and Technology, 25.03.2020 06:37
English, 25.03.2020 06:38
