Engineering, 06.06.2020 16:59 Unstinct

If the switching frequency is given as 16.7 kHz, VIN =15v, and the output is 5v as in section 1, draw the waveform of Vs2 and indicate the duty ratio D. Vout = DVIN. If the output needs to increase, will D increase or decrease? Note that the waveform of Vs2 is a square wave that contains the DC output Vout as well as harmonics. The lowest harmonic has the frequency of 16.7 kHz (from Fourier series expansion), which is also the switching frequency. Also, note that LC in the above converter circuit consists of a second order low pass filter with a corner frequency of LaTeX: \omega_c=1/\sqrt[]{LC}ω c = 1 / L C. To significantly reduce the harmonics, LaTeX: \omega_cω c must be much less than the switching frequency. Why? Assume LaTeX: \omega_cω c =0.1*switching frequency, calculate L and C (assume one and calculate the other).

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

You know the right answer?

If the switching frequency is given as 16.7 kHz, VIN =15v, and the output is 5v as in section 1, dra...

Questions