subject
Engineering, 05.06.2020 05:02 kj44

Choose the most appropriate answer in each of the following cases (with a brief justification). A: Given a channel capacity C shared by N stations that generate data at maximum rates, the CDMA-based transmission of data using M-chip code sequences allows each station to enjoy an effective transmission bandwidth share B, where: (i) B ≈ C N (ii) B ≈ C M (iii) B → C(−) (iv) B ≈ C N+M

B: IEEE 802.3 Ethernet (CSMA/CD) specifies a minimum data packet size, because: (i) Applications always generate large sized data packets (ii) Channel efficiency increases by amortizing the header overhead across a certain minimum packet size (iii) The sender of a packet should transmit long enough to hear any collisions that may occur at the farthest end of bus (iv) The application programming becomes simpler by sending a less number of large-sized packets

C: In comparison to transmission over a wired network, the signal strength over a wireless network decays rapidly with respect to the distance of receiver, because: (i) Signal energy propagates faster over wireless medium than over wired medium (ii) Signal energy propagates in all directions over wireless medium, whereas energy propagates only in the direction of wired medium; (iii) Noise signals are stronger in wireless medium that in wired medium (iv) Signal is sent on a high frequency carrier over wireless medium, whereas signal is sent as baseband over wired medium.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
question
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
Choose the most appropriate answer in each of the following cases (with a brief justification). A:...
Questions
question
Biology, 06.09.2021 20:50
Questions on the website: 13722361