subject
Engineering, 05.06.2020 16:58 laylay120

A railroad runs form city A to city B, a distance of 800km, through mountainous terrain. The present one-way travel time (including time at intermediate yards) is 20 hours, and the rail freight rate is $20 per ton. There is a truck service that competes with the railroad, running over a roughly parallel road for approximately the same distance, at an average speed of 48km per hour and a rate of $30 per ton. A new highway is planned to replace the existing roads; it is expected that most of the traffic will be trucks (auto usage is expected to be negligible). The performance function of the new facility is t_T = t_0 + bV_T, where V_T is the flow in trucks per hour, t_0 = 10 hours, b = 0.08 hour per truck per hour. The railroad's estimate of the demand function is: V_T/V_R = a_0(t_r/t_R)^a_1 (c_T/c_R)^a_2 where t_T and t_R are the trip times (in hours) by truck and rail, respectively, c_T and c_R are the corresponding rates, V_T and V_R are the corresponding flows and a_0, a_1 and a_2 are parameters. The total demand is likely to remain constant at V_TOT = 200 tons per hour. The rail system is utilized at only a fraction of capacity, so its performance function is flat (travel time is constant, independent of volume). If a_0 = 1, a_1 = -1 and a_2 = -2, find the present flows of freight by truck and rail. Make an estimate of the equilibrium flows if the new highway were built. With the new highway built, what would the equilibrium flow be in each of the following two cases: if the railroad dropped its rate to $15 per ton? if truckers were taxed $5 per ton to help pay for the new highway?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
You know the right answer?
A railroad runs form city A to city B, a distance of 800km, through mountainous terrain. The present...
Questions
question
Mathematics, 15.10.2019 11:30
question
Biology, 15.10.2019 11:30
question
Biology, 15.10.2019 11:30
question
History, 15.10.2019 11:30
Questions on the website: 13722363