Engineering, 05.06.2020 15:59 lburch112

Convergent divergent nozzle is designed to expand air at air from chamber in which the pressure is 800 kpa and the temperature is 40 c to give mach no 2.5 the throat are for the nozzle is .0025 m^{2} 1- The flow rate through the nozzle under design conditions
2- The exit area of the nozzle
3- The design back-pressure and the temperature of air leaving nozzle with this back pressure
4-The lowest back-pressure for which there is only subsonic flow in the nozzle
5- The back-pressure at which there is a normal shock wave on the exit plane of nozzle
6- The back-pressure below which there are no shock waves in the nozzle
7-The range of back-pressures over which there are oblique shock waves in the exhaust from the nozzle
8- The range of back-pressures over which there are expansion waves in the exhaust from the nozzle
9- The back-pressure at which a normal shock wave occurs in the divergent section of the nozzle at a point where the nozzle area is half way between throat and exit plane the throat and exit plane areas.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Acommercial grade cubical freezer, 4 m on a side, has a composite wall consisting of an exterior sheet of 5.0-mm thick plain carbon steel (kst= 60.5 w/m k), an intermediate layer of 100-mm thick polyurethane insulation (kins 0.02 w/m k), and an inner sheet of 5.0- mm thick aluminium alloy (kal polyurethane insulation and both metallic sheets are each characterized by a thermal contact resistance of r 2.5 x 104 m2 k/w. (a) what is the steady-state cooling load that must be maintained by the refrigerator under conditions for which the outer and inner surface temperatures are 25°c and -5°c, respectively? (b) for power saving purpose, which wall material should be increased/reduced in. thickness in order to reduce 50% of the cooling load found in part (a)? redesign the thickness of the proposed material. 177 w/m-k). adhesive interfaces between the q=575.93 w

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

Answer

You know the right answer?

Convergent divergent nozzle is designed to expand air at air from chamber in which the pressure is 8...

Questions