Task (I )
In the field of Photovoltaic design, it is important to analyse the implemented desi...
Engineering, 31.05.2020 22:57 jaheimnorman590
Task (I )
In the field of Photovoltaic design, it is important to analyse the implemented design associated with the
inverter and the structure. You are working in Izzat Marji in the design and development department for
providing the analysis and verification of the related design. Your manager asked you to find the optimum
tilt angle between (27<θ<32) for design as shown in figure (1) below as well as to conduct a design in order
to verify your design using the Matlab program.
In your MATLAB window create a new script; add the following comment at the beginning of the code:
%this code for Task-(I) of Assignment. No.1.
In the same script/editor find the following:
 Θ1& Θ2 in degrees and radians.
 The sine, cosine, tangent, secant, cosecant and cotangent for optimum tilt angle Θ in degrees and
radians.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
Physics, 20.05.2020 19:00
History, 20.05.2020 19:00
Mathematics, 20.05.2020 19:00
Chemistry, 20.05.2020 19:00
Mathematics, 20.05.2020 19:00
English, 20.05.2020 19:00
Mathematics, 20.05.2020 19:00
Physics, 20.05.2020 19:00
Mathematics, 20.05.2020 19:00
Biology, 20.05.2020 19:00
Chemistry, 20.05.2020 19:00
Mathematics, 20.05.2020 19:00