Engineering, 21.05.2020 18:04 gujaratif932

A heated plate is built into the wall of a large room. The room is maintained at 300 K. The exposed surface of the plate is maintained at 400 K by a heater attached to the back of the plate. Assume the sides of the plate and back of the heater are perfectly insulated. The exposed surface of the plate (area 0.1 m^2 ) has an emissivity of 0.3 and a convection heat transfer coefficient of 6 W/m^2K with the room and air temperature of 300 K. Show resistance circuit for this problem and draw a picture to show relevant heat modes on system to receive full points. Calculate the following:

a. Find the net radiant heat flux from the plate surface, q1"=
b. The required heater power, P=
c. The radiosity of the plate surface, J1=

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

Answer

You know the right answer?

A heated plate is built into the wall of a large room. The room is maintained at 300 K. The exposed...

Questions