subject
Engineering, 22.05.2020 16:57 dancemomsrule1

Write a QBasic program to sort aphetically the number of student names, each student name has first and last name like "Ahmed Yousef". The program should print the names before and after sorting. Also, the program should use "eod" as the last record in the file. The program should consider the upper and lower case for the names. 1. The first sorting should be based on the first name "Ahmed". Note that, the first names of two students may have the same first character and in this case, the sorting should be considered based on the second character of the first names of two students. 2. The second sorting should be based on the last name "Yousef". Note that, the last names of two students may have the same first character and in this case, the sorting should be considered based on the second character of the last names of two students

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 06.07.2019 02:30
1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction
Answers: 1
You know the right answer?
Write a QBasic program to sort aphetically the number of student names, each student name has first...
Questions
Questions on the website: 13722367