subject
Engineering, 19.05.2020 21:00 norahramahi123

42. A vehicle has sagged rear springs and reduced rear curb riding height. This problem results
in?
A. Excessive positive camber on the front wheels
B. Excessive toe-out on the front wheels
C. Excessive positive caster on the front wheels
D. Excessive toe-in on the front wheels
43. On a vehicle equipped with rear parallel leaf springs and a solid rear axle, customer is
complaining that the vehicle reacts erratically (it darts) during turns. What is the most likely
cause of this complaint?
A. Incorrect ride height
B. Incorrect driveline angle
C. Loose rear axle U-bolts
D. Missing jounce/rebound bumpers
44. A power steering pump is being tested with a pressure gauge for maximum output pressure.
Which of the following statements is correct?
A. The pressure gauge should be attached to the pump return port
B. The steering wheel should be held in the right lock position
C. A maximum output pressure dead heading test should last no longer than 5 seconds
D. One should check output pressure with engine speed above 4000rpm

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
question
Engineering, 04.07.2019 18:20
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
question
Engineering, 04.07.2019 18:20
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
question
Engineering, 04.07.2019 19:20
Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.
Answers: 1
You know the right answer?
42. A vehicle has sagged rear springs and reduced rear curb riding height. This problem results
Questions
question
Mathematics, 09.11.2020 22:50
question
Mathematics, 09.11.2020 22:50
Questions on the website: 13722361