A heat exchanger takes compressed liquid water and converts it into steam with a temperature and pressure of 20 Mpa and 480 C; respectively. Steam is used to generate work Wa in a turbine with an isentropic efficiency of 78%. Steam that exits the turbine at 14 Mpa is used in a second identical turbine (same efficiency) after reheating it to 500 C (with the same heating exchanger). Once the steam exits the second turbine it passes through a condenser (working at a pressure of 6 Kpa) before being pumped (with an internal reversible and adiabatic pump) back to the heat exchanger.

Required:
a. Sketch a representative T-S diagram of the cycle.
b. Work done by the first turbine (KJ/Kg).
c. Work done by the second turbine (KJ/Kg).
d. Quality of steam leaving the second turbine.
e. Cycle thermal efficiency.

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

A3-mm-thick panel of aluminum alloy (k 177 w/m-k, c 875 j/kg-k and ? = 2770 kg/m) is finished on both sides with an epoxy coating that must be cured at or above t,-150°c for at least 5 min. the production line for the curing operation involves two steps: (1) heating in a large oven with air at ts,0-175°c and a convection coefficient of h, 40 w/m2. k, and (2) cooling in a large chamber with air at 25°c and a con- vection coefficient of he 10 w/m2.k. the heating portion of the process is conducted over a time interval te which exceeds the ime required to reach 150°c by 5 min (h = r + 300 s). the coating has an emissivity of ? = 0.8, and the temperatures of the oven and chamber walls are 175 and 25°c, respectively. if the panel is placed in the oven at an initial temperature of 25°c and removed from the chamber at a safe-to-touch tempera ture of 37°c, what is the total elapsed time for the two-step curing operation?

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.