Engineering, 07.05.2020 03:14 tashai3138
Determine Vo for the network of positive clamper, negative half cycle. Vin is -20V, C is 1microF, and resistor is 1000kohm.
for the input indicated and draw the output signal
Note that the frequency is 1000 Hz, resulting
in a period of 1 ms and interval 0.5ms
between levels. The analysis will begin with period t1 which is T/2 to t2 which is T of the input signal since the diode
Is in its short circuit state.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 08:10
Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
You know the right answer?
Determine Vo for the network of positive clamper, negative half cycle. Vin is -20V, C is 1microF, an...
Questions
Mathematics, 28.04.2021 16:50
English, 28.04.2021 16:50
Mathematics, 28.04.2021 16:50
Mathematics, 28.04.2021 16:50
English, 28.04.2021 16:50
Mathematics, 28.04.2021 16:50
