Engineering, 06.05.2020 20:39 jokihahorton510
A solid square rod is cantilevered at one end. The rod is 0.8 m long and supports a completely reversing transverse load at the other end of ±1.3 kN. The material is AISI 1080 hot-rolled steel. If the rod must support this load for 3 × 104 cycles with a design factor of 1.5, what dimension should the square cross section have? Neglect any stress concentrations at the support end.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
You know the right answer?
A solid square rod is cantilevered at one end. The rod is 0.8 m long and supports a completely rever...
Questions
Mathematics, 05.03.2021 07:00
Health, 05.03.2021 07:00
Mathematics, 05.03.2021 07:00
Medicine, 05.03.2021 07:00
Mathematics, 05.03.2021 07:00
Business, 05.03.2021 07:00
Mathematics, 05.03.2021 07:00
Mathematics, 05.03.2021 07:00
Chemistry, 05.03.2021 07:00
Biology, 05.03.2021 07:00
Mathematics, 05.03.2021 07:00
Mathematics, 05.03.2021 07:00
History, 05.03.2021 07:00
Mathematics, 05.03.2021 07:00
