Engineering, 06.05.2020 03:40 bartfrank447

Consider a 2-foot wide rectangular lab flume. Two sharp-crested weirs are available for use: one is a contracted rectangular weir that is 12 inches wide (L = 12 inches) and the other is a v-notch weir with an angleof 90°. Either one could be installed in the downstream end of the flume to measure the flowrate. (a) Draw each weir to scale – an end-view as if you are downstream looking back upstream at the weir, not a longitudinal profile. Assume the dimension P (distance from bottom of flume to lowest point of the weir) is 8 inches and the maximum H is 6 inches. (b) If the smallest head over the weir (H) that you can measure is 0.01 ft, what is the lowest flowrate that you can measure with each weir? (c) If the construction of the flume and weirs limits you to a maximum H of 6 inches, what is the maximum flowrate that you can measure with each weir? (d) If you are planning an experiment that requires precise measurement of low flowrates, which weir would be a better choice? Explain why

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

You know the right answer?

Consider a 2-foot wide rectangular lab flume. Two sharp-crested weirs are available for use: one is...

Questions