subject
Engineering, 06.05.2020 01:36 OwONuzzlez

The dry- and the wet- bulb temperatures of atmospheric air in a 5 meter*5 meter*3 meter room at 1 atm (101.325 kPa) pressure are measured with a sling psychrometer and determined to be 25 and 15 °C, respectively. Calculate (a) The specific humidity, (b)The relative humidity, (c) The dew point temperature, (d)The enthalpy of the moist air, (e) The mass of the dry air in the room. (f) If the moist air is cooled at a constant pressure to 5 °C, find the amount of water removed per unit mass of dry air in this cooling process. (g)If the moist air is cooled at a constant volume to 5 °C, find the temperature at which condensation actually begins, in °C.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.
Answers: 1
You know the right answer?
The dry- and the wet- bulb temperatures of atmospheric air in a 5 meter*5 meter*3 meter room at 1 at...
Questions
question
Physics, 30.07.2019 19:00
question
Computers and Technology, 30.07.2019 19:00
Questions on the website: 13722363