Engineering, 05.05.2020 04:42 biancaadenisee2

A defrost heater is integrated with the sun roof glass in order to prevent ice from forming. The sun roof begins at L1 = 0.3 m from the front of the roof and extends to L2 = 0.6 m. The roof is W = 1.2 m wide. The car is driving at u[infinity] = 10 m/s through air at T[infinity] = -15°C. Assume that the properties of the air are conductivity k = 0.023 W/m-K, density  = 1.3 kg/m3 , viscosity  = 1.65x10-5 Pa-s, and specific heat capacity c = 1003 J/kg-K. The defrost heater is a thin sheet of electrically resistive material that covers the entire sun roof and transfers a uniform heat flux to the glass. The convection coefficient between the interior surface of the roof and the cabin air is sufficiently low that convection heat transfer with the interior can be neglected. Assume that the flow over the roof remains laminar. Do not use a correlation to solve this problem; instead, use your conceptual knowledge of boundary layer behavior to estimate the answers

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

You know the right answer?

A defrost heater is integrated with the sun roof glass in order to prevent ice from forming. The sun...

Questions