Engineering, 05.05.2020 04:24 yeeeeeeeeeeet21

Carbon disulfide has the following physical properties:Flashpoint -22Â°FBoiling point 46.5Â°CDensity 1.261Vapor density 2.64Lower flammable limit 1.3%Upper flammable limit 50%8-hour TWA PEL 20 ppm

An industrial process liberates 3 cubic feet of carbon disulfide per hour into a room that measures 10 feet by 20 feet and has a ceiling height of 8 feet.

(a) Calculate the minimum general exhaust ventilation (cubic feet/hour) necessary to prevent a general safety hazard for the process.
(b) Calculate the minimum general exhaust ventilation (cubic feet/hour) necessary to prevent a general health hazard for the process.
(c) Carbon disulfide is which of the following: 1. Class IA flammable liquid 2. Class IB flammable liquid 3. Class IC flammable liquid 4. Class II combustible liquid 5. Class III combustible liquid

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Carbon disulfide has the following physical properties:Flashpoint -22Â°FBoiling point 46.5Â°CDensity...

Questions