Engineering, 05.05.2020 07:16 kelyanthecrafte

Nsider the system below: (a) Derive the equation of motion of the system using both newton’s second law and the energy method. (b) Assume a value for m, r, J, k and c and plot the response of the system using Matlab or Python. Your code should superimpose the analytical solution on top of the numerically obtained one. Assume initial conditions for your system and F(t) = 0. (c) Change the parameters values in your system so that the system is undamped, overdamped, critically damped and underdamped. Plot the response of the system using Matlab or Python [both analytically and numerically in the same plot]. Assume F(t) = 0. (d) Assume a form for F(t) so that the system is unstable and characterize the type of instability. Plot the solution using Matlab or Python. (e) Assume a form for F(t) so that the system is at (1) resonance and (2) is beating. Plot the solution using Matlab or Python. (f) Solve the equation of motion of the system if

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Wiy doeres rere okhn a pump whon working betwon the same pressure range?

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Acommercial grade cubical freezer, 4 m on a side, has a composite wall consisting of an exterior sheet of 5.0-mm thick plain carbon steel (kst= 60.5 w/m k), an intermediate layer of 100-mm thick polyurethane insulation (kins 0.02 w/m k), and an inner sheet of 5.0- mm thick aluminium alloy (kal polyurethane insulation and both metallic sheets are each characterized by a thermal contact resistance of r 2.5 x 104 m2 k/w. (a) what is the steady-state cooling load that must be maintained by the refrigerator under conditions for which the outer and inner surface temperatures are 25°c and -5°c, respectively? (b) for power saving purpose, which wall material should be increased/reduced in. thickness in order to reduce 50% of the cooling load found in part (a)? redesign the thickness of the proposed material. 177 w/m-k). adhesive interfaces between the q=575.93 w

Answers: 2

Answer

Engineering, 06.07.2019 02:30

Define thermoplastic polymers and thermosetting polymers in terms of their structures, and (ii) describe briefly a process suitable for the production of products from each type of polymer.

Answers: 3

Answer

You know the right answer?

Nsider the system below: (a) Derive the equation of motion of the system using both newton’s second...

Questions