Engineering, 05.05.2020 09:20 whocares1234

Work and heat transfer calculation in a closed system

Find the pressure, temperature and volume at the end of each of the four processes. Then calculate the work done during each process and the net amount of work done. Finally calculate the net amount of heat transfer comparing the very initial and the very final states.

Nitrogen T1 (°C): 90, P1 (kPa): 530, m(kg): 9.3

process1: Isobaric expansion and the volume increased by 70%

process2: Isothermal expansion to a pressure of 10% of the initial pressure.

process3: Polytrpic comprission with n = 1.2 to the same initial process.

process4: Isochoric cooling to reach a pressure equal to 40% of the initial pressure

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

You know the right answer?

Work and heat transfer calculation in a closed system

Find the pressure, temperature and...

Questions