subject
Engineering, 06.05.2020 06:35 firstone04kr

Develop a spreadsheet using the Modified Puls method to route runoff through the specified pond configuration: Storage - At a stage of 0 ft (brim full), the pond has an area of 1 acre. From a stage of 0 ft to a stage of 3 ft, the pond increases to an area of1.5 acres. From a stage of 3 to 5 ft, the pond increases to an area of 2.25 acres. The stage should not increase above 5 ft Hint: develop an equation for this stage-area relationship for use in spreadsheet Hint: After areas are calculated for each stage, they must be converted to storage iven, see attached spreadsheet The pond has an outlet structure with a 6 inch orifice with the invert set at a stage of 0 The pond has a weir set at a stage of 2 that is 6 feet long Change int5 min Deliverables a) Draw a cross section of the pond showing the changes in pond size as the stage increases. Include a cross section of the outlet structure showing the two outlets set at the correct stage b) Develop a stage / storage relationship for the pond from a stage of 0 to 5 ft. c) Develop a stage / discharge relationship for the pond from a stage of 0 to 5 ft d) Develop a graph showing the relationship between outflow and 2S*/dt + O+ e) Use the attached table as a guide to route the given inflow hydrograph through the system (note, continue the routing until outflow stops or recedes to a very lovw eve f) Graph the inflow and outflow hydrographs on top of one another *provide items b, c, d, e and f as tables or graphs as appropriate

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
You know the right answer?
Develop a spreadsheet using the Modified Puls method to route runoff through the specified pond conf...
Questions
question
Mathematics, 06.02.2021 01:00
question
Mathematics, 06.02.2021 01:00
question
Chemistry, 06.02.2021 01:00
question
Biology, 06.02.2021 01:00
Questions on the website: 13722363