subject
Engineering, 06.05.2020 08:28 Bettie55

A combined cycle power plant to generate a net power output of 550 MW. The maximum temperature of the Brayton cycle is 1150 K. Air intake condition is 100 kPa and 30°C. Condenser pressure of the Rankine cycle is 45 kPa. Boiler (heat exchanger) pressure of the Rankine cycle is 10 MPa. The isentropic efficiency of the gas turbine is 0.87 and that of the compressor is 0.85. Isentropic efficiency of the feedwater pump is 0.8, and that of the steam turbine is 0.81. Use constant specific heats for air at the inlet temperature to each component. Use EES to:1- design the cycle (basic design = a cycle that does not violate any laws2 - run optimization trials to reach a maximum overall thermal efficiency3 - run performance trials to show the effect of Brayton pressure ratio on the thermal efficiency while keeping the basic design for the Rankine cycle4 - Add second law analysis to your EES code and generate data for irreversibility and 2nd - law efficiency of each of the components of both cycles

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
question
Engineering, 04.07.2019 19:20
A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.
Answers: 1
question
Engineering, 06.07.2019 02:30
A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush
Answers: 3
You know the right answer?
A combined cycle power plant to generate a net power output of 550 MW. The maximum temperature of th...
Questions
question
Physics, 18.10.2019 18:20
Questions on the website: 13722365