Engineering, 25.04.2020 00:33 scasemere

Calculate and plot the radial and circumferential stress distribution in the left ventricle at the end of systole (P-80mmHg, assume that the ventricle is a spherical shell). The inner radius of the heart is 3.2cm and the outer radius of the heart is 3.8cm. The external pressure surrounding the heart is negative 1mmHg. Under a disease condition where the heart muscle thickens, calculate the radial and circumferential stress distribution in the left ventricle at the end of systole and at peak systole. Under these conditions the pressure remains the same but the inner wall radius is 3cm and the outer wall radius is 4.2cm. Compare this to normal conditions and comment. 2.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Wiy doeres rere okhn a pump whon working betwon the same pressure range?

Answers: 2

Answer

You know the right answer?

Calculate and plot the radial and circumferential stress distribution in the left ventricle at the e...

Questions