Engineering, 24.04.2020 20:07 haileysolis5

The parameters of an RLC circuit with an input voltage of Upper E (t )are given. Substitute the steady-state component Upper I Subscript sp Baseline (t )equalsUpper A cosine omega t plus Upper B sine omega t into the following equation, using the appropriate value of omega, to find the steady periodic current in the form Upper I Subscript sp Baseline (t )equalsUpper I 0 sine (omega t minus delta ). Upper L Upper I double prime plus Upper R Upper I prime plus StartFraction 1 Over Upper C EndFraction Upper I equalsUpper E prime (t )where Requals50 Upper Omega, Lequals20 H, Cequals0.05 F, Upper E (t )equals100 cosine 4 t V Find the steady periodic current in the form Upper I Subscript sp Baseline (t )equalsUpper A cosine omega t plus Upper B sine omega t. The steady periodic current is Upper I Subscript sp Baseline (t )equals nothing.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

You know the right answer?

The parameters of an RLC circuit with an input voltage of Upper E (t )are given. Substitute the stea...

Questions