Engineering, 24.04.2020 19:37 sarita59

We would like to bolt the cantilevered beam to the column using a bolt pattern with two bolts. We are considering two possibilities: The bolts will be arranged in-line vertically, 5 inches apart, centered in the 6x6 in box, or, the bolts will be arranged in-line horizontally, 5 inches apart, centered in the 6x6 in box. Determine if one of the arrangements is preferable. Prove your point. You can do this by calculating the worst shear stress on a bolt in each case and selecting the case with the lesser shear stress.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

You know the right answer?

We would like to bolt the cantilevered beam to the column using a bolt pattern with two bolts. We ar...

Questions