subject
Engineering, 23.04.2020 20:14 zamakun

Complex poles cmd zeros. Sketch the asymptotes of the Bode plot magnitude and phase for each of the listed open-loop mmsfer fuoctions. and approximate the transiti at the stX'ond-order break point. based on the value of the ... ,. ,, 410. The Frequency-Response Design Method damping ratio. After completing the hand sketches, verify your result using Mallab. Tum in your hand sketches and the Matlab results on the same scales.

(a) L(s) = s2 + 3~r + 10
(b) L(s) = s(s2 + ~s + 10)
(c) L(s) = (s2 + 2s + 8) s(s2 + 2s + 10)
(d) L(s) = (s2 +I) s(s• +4)
(e) L(s) = (s:? +4) s(.r~ + I) 6

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
question
Engineering, 04.07.2019 18:20
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
question
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
You know the right answer?
Complex poles cmd zeros. Sketch the asymptotes of the Bode plot magnitude and phase for each of the...
Questions
question
Mathematics, 20.01.2020 03:31
question
Mathematics, 20.01.2020 03:31
question
Chemistry, 20.01.2020 03:31
Questions on the website: 13722367