Engineering, 23.04.2020 16:33 chrisraptorofficial

The production of copper foil used in printed circuit boards is accomplished by an electroforming operation in which a slowly rotating titanium drum acts as the cathode to plate copper onto its surface. The drum diameter = 500 mm and its width = 450 mm. At any moment during the process, 35% of the drum’s circumferential surface area is submerged in the electrolytic bath (the ends of the drum are insulated to prevent plating). As the copper foil exits the bath, it is peeled from the drum surface. If the thickness of the foil = 0.04 mm on the drum surface when it is peeled, and the process operates at a current of 450 amps, determine the rotational speed of the drum.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

In the winter, in order to keep the classroom steadily at 68 f before 10 pm, heating with an average rate of 42,000 btu/hr is provided. assume the outdoor temperature maintains at 32°f, determine the electrical power (kw) required to (a) operate a reversible heat pump (b) operate a real heat pump with a cop (7) of 4.5 and (c) operate an electrical-resistance heater.

Answers: 3

Answer

Engineering, 06.07.2019 03:10

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

Answer

You know the right answer?

The production of copper foil used in printed circuit boards is accomplished by an electroforming op...

Questions