Engineering, 21.04.2020 18:20 hamptonjeleesa

Using the DE-Goodman criteria and a design factor of 1.5, calculate the diameter based on the shaft’s loadings and your guess for the shaft’s diameter at the critical location, what is the shaft diameter and what is the factor of safety against yielding? Assume the notch radius to be 0.02 in. (You must provide an answer before moving to the next part.)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Aplate of dimensions 3 m x 3 m is placed 0.37 mm apart from a fixed plate. the plate requires a force of 2n to move at speed of 45 cm/s. evaluate the viscosity of the fluid in between the plates

Answers: 3

Answer

You know the right answer?

Using the DE-Goodman criteria and a design factor of 1.5, calculate the diameter based on the shaft’...

Questions