Engineering, 21.04.2020 17:46 chony83

Consider a refrigeration truck traveling at 55 mph at a location where the airtemperature is 80F. The refrigerated compartment of the truck can be considered to the a 9-ft-wide,8-ft-high, and 20-ft-long rectangular box. The refrigeration system of the truck removes heat at arate of 600 Btu/min. The outer surface of the truck is coated with a low-emissivity material, andthus radiation heat transfer is very small. Determine the averagetemperature of the outer surface ofthe refrigeration compartment of the truck. Assume the air flow over the entire outer surface to beturbulent, and the heat transfer coefficient at the front and rear surfaces to be equal to that on sidesurfaces.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 19:10

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

Answer

You know the right answer?

Consider a refrigeration truck traveling at 55 mph at a location where the airtemperature is 80F. T...

Questions