Engineering, 21.04.2020 16:17 igtguith

A company produces electric insulators. The strength of the insulators is important since a broken insulator may cause a short circuit. Unfortunately, the strength varies significantly due to the material. Because of the expense, only a limited number of insulators could be tested. The engineers sampled 25 insulators (From a production run of 200), and conducted a destructive test to determine the force that was required to break the insulators. The mean value of this force was 1723 lbf with a sample standard deviation of 90 lbf. You may approximate the population standard deviation with the sample standard deviation for the following questions.

a. Determine if the population is large enough or if a finite population correction (FPC) factor is needed. If so, what is the FPC factor?

b. For 95% confidence, determine the margin of error (+ lbf)

c. For these conditions, estimate the range of the probable population mean. Provide lower and upper values. For 95% confidence, determine the margin of error ( Assume the same mean and sample standard deviation. What is one advantage and one disadvantage of using 50 insulators instead of 25 insulators?

d. lbf) if 50 insulators were tested.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

You know the right answer?

A company produces electric insulators. The strength of the insulators is important since a broken i...

Questions