Engineering, 18.04.2020 19:28 mleighaj9560

A) Calculate the cross-sectional area, in mm², of a piece of copper wire, 40 m in length
and having a resistance of 0.25 2. Take the resistivity of copper as 0.02 x 10-6 22 m.
b) A coil of 20 2 resistance is joined in parallel with a coil of R2 resistance. This
combination is then joined in series with a piece of apparatus A, and the whole circuit
connected to 100 V mains. What must be the value of R so that A shall dissipate 600
W with 10 A passing through it?
c) A load taking 200 A is supplied by copper and aluminium cables connected in parallel.
The total length of conductor in each cable is 200 m, and each conductor has a cross-
sectional area of 40 mm2. Calculate:
the voltage drop in the combined cables;
the current carried by each cable; .
the power wasted in each cable. Take the resistivity of copper and aluminium
as 0.018 um and 0.028 um respectively.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

You know the right answer?

A) Calculate the cross-sectional area, in mm², of a piece of copper wire, 40 m in length
and ha...

Questions