subject
Engineering, 17.04.2020 00:03 BlueExorcistReaper

An air conditioner must maintain a computer laboratory at 18°C when the outside temperature is 30°C. The thermal load that must be removed from the room consists of heat transfers entering through the walls and roof of the laboratory at a rate of 75,000 kJ/h and from the computers, lighting, and occupants at a rate of 15,000 kJ/h. (a) Determine the maximum theoretical coefficient of performance and the corresponding minimum theoretical power required by the air conditioner, in kW (Ans: COPR, max = 24.25; W min = 1.03 kW;) (b) If the actual power required by the air conditioner for this duty is 8.3 kW, determine the coefficient of performance. (Ans: COPR = 3.01) (c) If the given temperature and thermal load are observed for a total of 100 hours and electricity costs are 13 cents per kW-h, determine the cost, in $, over that period for each of cases (a) and (b). (Ans: case (a), cost = $ 13.4; case (b), cost = $ 107.9)

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
question
Engineering, 04.07.2019 19:10
What is creep? what is stress relaxation?
Answers: 1
You know the right answer?
An air conditioner must maintain a computer laboratory at 18°C when the outside temperature is 30°C....
Questions
question
Mathematics, 05.03.2021 04:30
question
Mathematics, 05.03.2021 04:30
question
Social Studies, 05.03.2021 04:30
Questions on the website: 13722363