If the length of the lever arm is increased, what happens to the output force?
Output force in...
Engineering, 16.04.2020 23:36 shadoris26
If the length of the lever arm is increased, what happens to the output force?
Output force increases
Output force decreases.
Output force remains the same.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
You know the right answer?
Questions
Spanish, 25.09.2020 02:01
Mathematics, 25.09.2020 02:01
History, 25.09.2020 02:01
History, 25.09.2020 02:01
Spanish, 25.09.2020 02:01
History, 25.09.2020 02:01
English, 25.09.2020 02:01
Mathematics, 25.09.2020 02:01
English, 25.09.2020 02:01
Mathematics, 25.09.2020 02:01
Mathematics, 25.09.2020 02:01
Mathematics, 25.09.2020 02:01
Mathematics, 25.09.2020 02:01
