Engineering, 16.04.2020 18:23 nataliaguadaluoupa25

A countershaft in a machine has two pulleys mounted on it for power transmission and is supported by cylindrical roller bearings at the ends. The countershaft runs at 1,500 revolutions per minute. The belt tension on the loose side of Pulley 1 is 15% of the tension on tight side. The pulleys are 50 mm wide. The bearings must have a minimum life of 90,000 hours. Design the shaft, mounting components and bearings. The design will include the following items. (1) Shaft material selection (2) Shaft diameters at critical locations along the shaft (using a factor of safety of 1.5) (3) Selection and design of the components needed for mounting the shaft and bearings (4) Selection and design of bearings

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 06.07.2019 02:30

On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)

Answers: 2

Answer

You know the right answer?

A countershaft in a machine has two pulleys mounted on it for power transmission and is supported by...

Questions