Engineering, 16.04.2020 02:30 cbonner191

Add ‘withDebounce. v’ from the course directory to your Vivado project. Still use ‘Bouncetb. v’ as testbench, but this time, modify the name of uut in ‘Bounce_tb. v’ so that ‘withDebounce. v’is being tested instead of ‘noDebounce. v’. Run the simulation of ‘withDebounce. v’. Check theoutput waveforms. Does the counter in ‘withDebounce. v’ work as expected? Why or Why not?

In the withDebounce waveform we can appreciate that the counter in WithDebounce works as expected as we are able to see that the LED output behaves as desired, going only from 0 to 6 and not changing repeatedly alongside the changes of the bounce button

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2

Answers: 2

Answer

You know the right answer?

Add ‘withDebounce. v’ from the course directory to your Vivado project. Still use ‘Bouncetb. v’ as t...

Questions