Engineering, 15.04.2020 21:16 gabbystar517

Design a natural gas power engine which can provide 1MW power output. In the design, you have to provide us the pressure ratio, inlet/outlet diameters of the compressor and turbine in the final answer. The required stoichiometric air-fuel ratio and heating value of natural gas can be found through google searches. Your power engine should be as small as possible as well as satisfying the following constraints :

(a) The maximum pressure of your natural gas power engine should not be higher than 10% of the fatigue limit of steel

(b) The maximum temperature of your power engine should not higher than 1000 K

(c) The fluid velocity should not be higher than 50% of the sound speed.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

You know the right answer?

Design a natural gas power engine which can provide 1MW power output. In the design, you have to pro...

Questions