subject
Engineering, 15.04.2020 15:51 Nprz84

(Construction Management Fundamental) Civ / Arch E

An excavator ($300/hour) with a 4 cubic yard bucket loads trucks ($200/hour each).Trucks carry 18 cubic yards. Each cycle of the excavator is 30 seconds (4 yd3 each 30

seconds). We can either load the truck full (18 yd3) in 5 cycles or partially full (16 yd3) in 4 cycles. Assume 100% productive (60 minutes/60 minutes)In either case, the truck takes 6.5 minutes to travel, dump and return.

a. Option 1: 5 cycles of the excavator, 18 yd3 in the truck.

i. Determine the number of trucks to balance the operation, to 1 decimal place

ii. Round the number of trucks up, determine the productivity in yd3/hour

iii. Determine the cost per hour (round to nearest dollar) and cost per cubic yard(round to nearest cent/yd3) to load and haul the soil.

b Option 2: 4 cycles of the excavator, 16 yd3 in the truck.

i. Determine the number of trucks to balance the operation, to 2 decimal places

ii. Round the number of trucks up, determine the productivity in yd3/hour

iii. Determine the cost per hour and cost per cubic yard to load and haul the soil

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 08:10
Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed
Answers: 1
question
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
You know the right answer?
(Construction Management Fundamental) Civ / Arch E

An excavator ($300/hour) with a 4 cub...
Questions
question
Engineering, 15.06.2021 01:00
question
Mathematics, 15.06.2021 01:00
question
Mathematics, 15.06.2021 01:00
Questions on the website: 13722363