Engineering, 15.04.2020 03:51 TrapQueen665

Part (IV) Following sketch show a proposed retaining construction project. Please do the
following:
2) Find factor of safety against sliding and overturning (F. S. > 1.5), perform eccentricity (middle third rule, e < ± B/6), check for qmax (qmax < Allowable bearing capacity) and qmin (No tensile stresses). If the wall is unsafe change the dimensions of slab and/or wall/construct key at base. Use the trial and error method to make sure all the safety checks are performed, and wall is safe. The soil above base slab (shown as shaded part) can be considered while performing the checks. There is no passive fill on other side.

Part (IV) Following sketch show a proposed retaining construction project. Please do the following:

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

You know the right answer?

Part (IV) Following sketch show a proposed retaining construction project. Please do the
follo...

Questions