subject
Engineering, 14.04.2020 16:31 wittlemarie

A spur gearset has a pinion speed of 1120 rev/min. there are 17 teeth on the pinion and 51 teeth on the gear. the pressure angle is 20 deg and the overload factor ko=1 the diameteral pitch is 6 tetth/ in and the face width of 2 in the pinion cycle life is to be 108 rev at a reliablity of 0.99. the quality number is 5. the material is a through hardened steel, grade 1 with brinell hardness of 232 core and case of both gear. for a design factor of 3 what is the capacity in hp of the pinion cnosidering only bending Ks=1

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:20
Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above
Answers: 1
question
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
You know the right answer?
A spur gearset has a pinion speed of 1120 rev/min. there are 17 teeth on the pinion and 51 teeth on...
Questions
question
Mathematics, 08.12.2020 01:00
question
Mathematics, 08.12.2020 01:00
question
Mathematics, 08.12.2020 01:00
question
Mathematics, 08.12.2020 01:00
Questions on the website: 13722367