Engineering, 12.04.2020 19:18 parrazm2022

Air at a pressure and temperature of 30 kPa and –20°C flows at a Mach number of 3.5 down a wide duct. The upper wall of the duct turns sharply through an angle of 5° leading to the formation of an oblique shock wave as shown in the figure. Find the Mach number, temperature, and pressure behind the shock wave. As shown in the figure, this shock wave impinges the lower wall of the duct exactly at a point where the lower wall turns away from the flow through an angle of 2°. Find the Mach number, pressure, and temperature behind the “reflected” wave.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What are the major differences between injection molding and extrusion?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b.s. and b.s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

Answer

You know the right answer?

Air at a pressure and temperature of 30 kPa and –20°C flows at a Mach number of 3.5 down a wide duct...

Questions