Engineering, 09.04.2020 01:31 quece233
Suppose that a single factor experiment with five levels of the factor has been conducted. There are three replicates and the experiment has been conducted as a complete randomized design. If the experiment had been conducted in blocks (where each replicate is a block), would this reduce the degrees of freedom of the error? If so, by how much? If not, explain why not
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
Suppose that a single factor experiment with five levels of the factor has been conducted. There are...
Questions
Mathematics, 05.05.2020 03:48
Biology, 05.05.2020 03:48
Mathematics, 05.05.2020 03:48
Mathematics, 05.05.2020 03:48
History, 05.05.2020 03:48
Mathematics, 05.05.2020 03:48
Mathematics, 05.05.2020 03:48
Biology, 05.05.2020 03:48
English, 05.05.2020 03:49
Mathematics, 05.05.2020 03:49
