subject
Engineering, 08.04.2020 04:50 niyah0623

A Newtonian Fluid flows steadily and continuously at 100oF through a 4500 foot horizontal pipe with constant cross-sectional area of 12.56 in2 . This fluid has a density of 53.6 lbm/ft3 , heat capacity of 0.420 BTU/lbm F and kinematic viscosity of 6.15x10-6 ft2 /sec. This pressure drop across the pipe under these conditions is 300 lbf/ft2 . Assuming fully developed, parabolic, laminar, incompressible flow, please calculate the maximum velocity and volumetric flow rate of the fluid in the pipe.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
question
Engineering, 06.07.2019 03:20
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.
Answers: 3
You know the right answer?
A Newtonian Fluid flows steadily and continuously at 100oF through a 4500 foot horizontal pipe with...
Questions
Questions on the website: 13722362