Engineering, 08.04.2020 02:35 iidoqeii16ovh8tk

Rocket scientists are testing a new three-stage rocket for delivering small payloads to low-Earth orbit. It has these characteristics

• Ispstage 1 = 300 s

• Ispstage 2 = 350 s

• Ispstage 3 = 400 s

• Payload mass = 1500 kg

• Structure mass stage 1 = 10,000 kg

• Structure mass stages 2 and 3 = 7500 kg each

• Propellant mass stage 1 = 50,000 kg

• Propellant mass stage 2 = 40,000 kg

• Propellant mass stage 3 = 35,000 kg

a) What is the initial mass of the entire vehicle?

b) What is the final mass of stage 1?

c) What is the ΔV of stage 1?

d) What is the initial mass of stage 2?

e) What is the final mass of stage 2?

f) What is the ΔV of stage 2?

g) What is the initial mass of stage 3?

h) What is the final mass of stage 3?

i) What is the ΔV of stage 3?

j) What is the total ΔV of the booster?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

Engineering, 04.07.2019 19:10

What is creep? what is stress relaxation?

Answers: 1

Answer

You know the right answer?

Rocket scientists are testing a new three-stage rocket for delivering small payloads to low-Earth or...

Questions