subject
Engineering, 07.04.2020 19:22 jamiria38

For the system in problem 4, suppose a main memory access requires 30ns, the page fault rate is .01%, it costs 12ms to access a page not in memory (this time includes the time necessary to transfer the page into memory, update the page table, and access the data). Also suppose a TLB hit requires 7ns, the cache miss rate is 3%, the TLB hit rate is 95%, a cache hit requires 15 ns. On a TLB or cache miss, the time required for access includes a TLB and/or cache update, but the access is not restarted. On a page fault, the page is fetched from disk, all updates are performed but the access is restarted . All references are sequential (no overlap, nothing done in parallel)

a.) Calculate the time for a TLB hit and a cache hit.

b.) Calculate the EAT (effective access time) for a TLB hit.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
You know the right answer?
For the system in problem 4, suppose a main memory access requires 30ns, the page fault rate is .01%...
Questions
question
Mathematics, 11.11.2020 19:50
question
Mathematics, 11.11.2020 19:50
question
Mathematics, 11.11.2020 19:50
Questions on the website: 13722367