Engineering, 07.04.2020 15:39 sbelgirl2000

You originally designed a system to control two motors with the following conditions and hardware: (1) Motor A (240V, 30A, 3Phase) operation is controlled by a magnetic motor starter (MMS) which contains a NO. Aux Contact (2) Motor A, is to START, and remain running when an operator presses a single N. O. push button (3) TO STOP Motor A. independent operators must simultaneously press two N. C. push buttons (4) Motor B (240V, 20A, 1 Phase) operation is controlled by a MMS which contains a N. O. Auxiliary Contact (5) Motor B can only operate if Motor A is running, and is controlled with a start-stop-station. Unfortunately, you received the opposite (3.N. O. push buttons, and 2.N. C. push buttons). After scrounging around you have the following hardware: a.2-120V MMS with N. Q. Aux Contacts b.1-NO Push Buttons c.2-120V Relays with NO and N. CCortacts d.2-N. C.Push Buttons II 13:39 15:14 1.00x

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

You know the right answer?

You originally designed a system to control two motors with the following conditions and hardware: (...

Questions