Engineering, 04.04.2020 11:28 lyss12326

A 12.5 mm diameter cylindrical rod fabricated from a 2014-T6 alloy is subjected to repeated tension-compression load cycling along its axis. The magnitudes of the maximum tensile and compressive stresses during cycling are 350 MPa and 50 MPa, respectively. Remember that compressive stresses are negative quantities. Estimate the fatigue lifetime of this cylindrical rod (in years), if it is cycled between these stress states sinusoidally with a frequency of 0.01 Hz. You may assume that the curves in Fig. 12 represent a 100% chance of failure.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Prove the equivalence between the two statements of the 2nd law of thermodynamics (i.e., a violation of one statement leads to the violatio the other statement)

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

You know the right answer?

A 12.5 mm diameter cylindrical rod fabricated from a 2014-T6 alloy is subjected to repeated tension-...

Questions