Engineering, 04.04.2020 02:43 aerisander02

G 4. Consider a stepper motor with two phases. Phase 1 is wound with two identical coils. Phase 2 is also wound with two identical coils. Therefore, there are eight wires that come out from the stator winding, four for each phase. (a) Connect the phase terminal wires in such a way that the motor can be used as a unipolar wound motor and draw a schematics for the amplifier circuit of the motor windings. (b) Connect the phase terminal wires in such a way that the motor can be used as a bipolar wound motor with series connected windings (two identical windings for each phase are connected in series). Draw the amplifier circuit and its connections to motor windings. (c) Connect the phase terminal wires in such a way that the motor can be used as a bipolar wound motor with parallel connected windings (two identical windings for each phase are connected in parallel). Draw the amplifier circuit and its connections to motor windings

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

Answer

You know the right answer?

G 4. Consider a stepper motor with two phases. Phase 1 is wound with two identical coils. Phase 2 is...

Questions