Engineering, 31.03.2020 22:35 shawk1468

3. Welfare effects of a tariff in a small country
atalog
tiers
Suppose Bangladesh is open to free trade in the world market for oranges. Because of Bangladesh's small size, the demand for and supply of oranges
in Bangladesh do not affect the world price. The following graph shows the domestic oranges market in Bangladesh. The world price of oranges is
Pw - $800 per ton
Bons
Success Tips
On the following graph, use the green triangle (trangle symbols) to shade the area representing consumer surplus (CS) when the economy is at the
free-trade colibrium. Then use the purple triangle (diamond symbols) to shade the area representing producer surplus (PS),
uccess Tips
D FOR YOU

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:20

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

Engineering, 06.07.2019 03:10

What is the direction and how to operate the lathe?

Answers: 2

Answer

Engineering, 06.07.2019 03:20

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

Answer

You know the right answer?

3. Welfare effects of a tariff in a small country
atalog
tiers
Suppose Bangladesh...

Questions