Engineering, 31.03.2020 00:26 quianna410

A sleeve made of SAE 4150 annealed steel has a nominal inside diameter of 3.0 inches and an outside diameter of 4.0 inches. It is pressed onto a solid shaft with a medium drive force fit. Specify the class of fit, dimensions for the shaft and sleeve, and calculate the stress in the shaft and sleeve after installation. Use the basic hole system. Is the design acceptable

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Determine the stoichiometric and actual air-fuel ratios and the mole flue gas composition for combustion with 15% excess air for raw indiana, pennsylvania raw coal.

Answers: 3

Answer

Engineering, 06.07.2019 04:30

Briefly discuss how plastic deformation occurs in crystalline materials discuss the five most important methods of strengthening of metals and alloys.

Answers: 2

Answer

You know the right answer?

A sleeve made of SAE 4150 annealed steel has a nominal inside diameter of 3.0 inches and an outside...

Questions