Engineering, 30.03.2020 23:17 evelin2318
Compare the use of a low-strength, ductile material (1018 CD) in which the stress-concentration factor can be ignored to a high-strength but more brittle material (4140 Q&T at 400°F) in which the stress-concentration factor should be included. Given: Fy = 175 lb, Fx = 87.5 lb, and Fz = 131.25 lb.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
Engineering, 04.07.2019 19:10
In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?
Answers: 3
You know the right answer?
Compare the use of a low-strength, ductile material (1018 CD) in which the stress-concentration fact...
Questions
Mathematics, 10.12.2019 07:31
Mathematics, 10.12.2019 07:31
Mathematics, 10.12.2019 07:31
Computers and Technology, 10.12.2019 07:31
Mathematics, 10.12.2019 07:31
Mathematics, 10.12.2019 07:31
Mathematics, 10.12.2019 07:31
English, 10.12.2019 07:31
