Engineering, 30.03.2020 21:04 67555savchenko
An MgO component must not fail when a tensile stress of 30 MPa is applied. Determine the maximum allowable surface crack length for a loading/geometry with geometric factor of 1.92 Assume the major axis of the elliptical flaw is normal to the tensile loading axis.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
You know the right answer?
An MgO component must not fail when a tensile stress of 30 MPa is applied. Determine the maximum all...
Questions
Mathematics, 31.03.2020 04:05
Mathematics, 31.03.2020 04:05
Health, 31.03.2020 04:05
Mathematics, 31.03.2020 04:05
History, 31.03.2020 04:05
Mathematics, 31.03.2020 04:05
Mathematics, 31.03.2020 04:05
